Hangar |
Aircraft |
Category |
Date |
Preview |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 30-Aug-09 18:04 | | Views : 730 | The national insignia and letters will be painted on so to facilitate that, the stabilizer will not be attached until that's done. |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 30-Aug-09 17:59 | | Views : 717 | Everything is covered except the control surfaces which will be covered and painted before assembly. |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 30-Aug-09 17:58 | | Views : 821 | The nacelle is covered except for the area in front of the fill in and is glued in place. |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 30-Aug-09 17:55 | | Views : 732 | Hobbylite filler, 'fore & after |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 21:53 | | Views : 751 | Covering of the nacelles and stabilizer is next. |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 21:51 | | Views : 693 | The fuselage is completely covered except for the tail and nose blocks. The wing has been CA'd in place and filler added. |
|
Hangar |
Aircraft |
Category |
Date |
Preview |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 21:48 | | Views : 729 | A soft balsa 1/16" stringer for fill.... |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 21:47 | | Views : 713 | |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 13:35 | | Views : 665 | Since I'm covering too, here's a closer look. |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 13:33 | | Views : 798 | So you know where to cut... |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 25-Aug-09 19:48 | | Views : 741 | The wing halves were covered separately and have now been CA'd together and.....IT FITS!!! |
David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 23-Aug-09 17:34 | | Views : 728 | 2 scoops, please. I put filler into the scoop and used the rounded end of a small paint brush to round the contact area. Any further refinements will be done when covering and painting. 5 cents, please. |
|