| Hangar |
Aircraft |
Category |
Date |
Preview |
| Creosotewind | Rogers 40mm Bofors AA cannon | Parked | 04-May-10 15:21 |  |
| Views : 650 |
| First time trying this. I got a really good mold. I used the Alumilite starter kit. About $30, with enough rubber to make one mold, and enough resin to make several small castings. |
| Creosotewind | Rogers 40mm Bofors AA cannon | Parked | 04-May-10 15:19 |  |
| Views : 646 |
| To mold the tire I used Legos to make a dam. |
| Creosotewind | Rogers 40mm Bofors AA cannon | Parked | 12-Apr-10 11:05 |  |
| Views : 649 |
| The gun, only awaiting it's new set of tires. |
| Creosotewind | Rogers 40mm Bofors AA cannon | Parked | 12-Apr-10 11:04 |  |
| Views : 623 |
| Primed and ready for casting. The tire on the right is what came in the kit, my starting point. |
| Creosotewind | Rogers 40mm Bofors AA cannon | Parked | 12-Apr-10 11:03 |  |
| Views : 630 |
| One down, three to go. Actually I bought a resin casting kit. This will be my first attempt at casting. The nuts are from Verlinden. The center nut is an actual nut with a paper cover to overlay the bolt hole. Wait, is that a dirty term? |
| Creosotewind | Rogers 40mm Bofors AA cannon | Parked | 12-Apr-10 11:01 |  |
| Views : 594 |
| One wheel with its grooves. The background is a pattern I made to show the bolt spacing. It took several tries to cut one out that would work on the wheel. Combination of a compas and hand work with an X-Acto blade. The notch is where the valve stem would be. |
