|
Hangar |
Aircraft |
Category |
Date |
Preview |
hjlittman | Guillows Series 200 - SE5a | Build | 21-Jul-18 16:00 | | Views : 1167 | I traced Former 1 onto a single piece of 1/16" sheet, cut it out and glued it into the back of the plastic nose with the nose reinforcement spacers. Since the plastic nose is meant to go over Former 1 that makes the fuselage 1/16" longer, but who's going to notice? Then I made a simple box key using the opening that existed in Former 1. The top and bottom of the hole is curved so I simply made the top and bottom of the box to match the curves. The key is quite snug and is perfectly aligned but I'm still going to add a couple of neodymium magnets to hold it in place. I hate loose nose blocks. |
hjlittman | Guillows Series 200 - SE5a | Build | 12-Jul-18 15:29 | | Views : 1267 | I finshed the other side in 15 minutes and left for the dentist. Hint: half height formers are easier to install if you do it after the side keel in installed. More later today, Howard |
|