I think all is working again now. Please leave a comment on a photo somewhere if something you need is not working still.

Main Menu
User Login
User Name
Password



View By Aircraft
Users Aircraft

Browse Images

Virtual Aerodrome Image Browser ( Small / Large ) Show : All | Parked | Flying | Build | Aerial | Reference
Page (38 in total) :  <<   27   28   29   30   31   32   33   34   35   36   37  [ < Prev ] [ Next > ]
Hangar Aircraft Category Date Preview
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild22-Jul-07 09:51
Views : 977
A runway by the ocean!
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild22-Jul-07 09:51
Views : 1120
You can see the servo underneath the wing. The servo wire should somewhat blend in with the to-be-installed struts and support wires.
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild22-Jul-07 09:49
Views : 1020
Top wing now covered that ailerons are installed.
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild22-Jul-07 09:48
Views : 1727
And I now present - working ailerons! They are hinged with small bits of floppy disk material CA'd to the top of the wing and aileron.
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild22-Jul-07 09:44
Views : 957
Another reference shot of the aileron setup.
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild22-Jul-07 09:44
Views : 1026
Top view of the aileron installation. This setup gave much better results than the previous, it's a much more direct action, more positive response.
Hangar Aircraft Category Date Preview
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild22-Jul-07 09:42
Views : 944
Exit point for the aileron actuator cable.
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild22-Jul-07 09:42
Views : 932
Notching the bottoms of the ribs for the new cross stringer for the aileron opening.
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild21-Jul-07 16:18
Views : 995
Time to finish up the ailerons and cover and install the top wing.
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild21-Jul-07 16:17
Views : 1019
New aileron setup - wing cutouts and actuation cable now installed.
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild21-Jul-07 16:16
Views : 1016
Top view of the old setup. Not quite finished at this stage, the top cross bar on the wing aileron cutout was not installed.
jgoodGuillows Series 200 - Fokker DR-1 TriplaneBuild21-Jul-07 16:15
Views : 1032
Old aileron setup. I took these just before converting to a different method. The torque rod (wire) I used was not heavy enough gauge, and they were a bit sloppy.
Page (38 in total) :  <<   27   28   29   30   31   32   33   34   35   36   37  [ < Prev ] [ Next > ]