| Hangar |
Aircraft |
Category |
Date |
Preview |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 09:13 |  | | Views : 390 | | The crossmember planks are then slipped in UNDER the top and bottom center keels, with the crossmember plank ends sitting ON TOP of the rails, where they are pinned in place. The Rails are just high enough to raise the side edge of the finished former side, just above the building board. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 09:12 |  | | Views : 320 | | The Rails are 1/4" X 1/2" X 12" hard stick balsa, and the Crossmembers are 1/16" X 3/8" X 3" balsa planks. The crossmembers do not slide, but are pinned down to the rails, snugly sandwiching and holding each former. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 09:09 |  | | Views : 327 | | The Float lies sideways in the jig, with the top "flat" of the float, which is formed by the top flat edge of the formers and the top of the upper center Keel, - that flat is sitting flush to the nearest rail. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 09:06 |  | | Views : 340 | | I knew I had to make a jig/assembly fixture to securely hold the half-finished float, in order to glue the Float's "other side", half-formers and stringers. This is the little micro-jig setup I made, that uses the same principle as the larger jigs. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 08:58 |  | | Views : 300 | | BUILDING THE FLOATS - It was difficult cutting and getting the printwood parts right. All of the float formers sat crooked when standing on the float keels, because I cut them out crooked with the exacto knife - I had to sand them all to a right angle perpendicular edge mating surface. And all of my 10 second Cyano Acrylate "CA" glue bottles were either rock hard in the bottle, or had lost all of their potency. Luckily, I had one bottle of CA super glue from Dolarama - but it was 30 second glue, not 10 second glue - I found out the hard way ... |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 19-Sep-17 07:15 |  | | Views : 313 | | On Saturday October 14, there will be a "MODEL SHOW", open to everyone, inside the Historic Hangar at Windsor Airport, from 10 am to 3pm, open to all categories of models - airplanes, ships, cars, anything. It's your chance to see some great models, or show off your favorite models, and, if you want, enter your best models into the different categories, each with a prize. Inside the Historic Hangar you can talk to the volunteers who are tirelessly working to restore the Lancaster and Mosquito bombers. There is also a big BBQ with hotdogs and hamburgs for lunch. So bring the kids and have some fun at the Canadian Historical Aircraft Association’s third annual "MODEL SHOW" at the Historic Hangar at Windsor Airport on Saturday October 14, from 10 am to 3 pm, open to all models, and open to everyone. Visit CH2a.ca for details. |
|
|
