| Hangar |
Aircraft |
Category |
Date |
Preview |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Jun-14 19:54 |  |
| Views : 523 |
| I cut two parallel lines the width of the plastic, and the diameter of the inner circle in the plastic. I notched between the two lines and press-fit the "propellor" onto the cone. Again, it is removable for transport.The tailbone was then attached to the fuselage using a butterfly clip. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Jun-14 19:51 |  |
| Views : 597 |
| Using Ted's tail cone, I had a another friend cut out a 12"+ diameter piece of clear plastic. I painted the prop to look like it was spinning. I probably should be a bit more subtle, but with the yellow warning strips, it came out pretty effective. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Jun-14 19:49 |  |
| Views : 543 |
| The aileron linkage pieces can be seen in this photo. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Jun-14 19:48 |  |
| Views : 515 |
| Attached to the plane. The keyhole attachment is very solid, yet easy to remove for transport. You can see the footballs and antenna in place as well. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Jun-14 19:46 |  |
| Views : 482 |
| Parts are coming together. I attached the hard point body to the wing using screws. I cut keyhole slots in the wings, insert the screw heads and slid them back. Worked out great. Very solid attachment. |
| Creosotewind | Scratch Built Solid Models | Parked | 14-Jun-14 19:44 |  |
| Views : 457 |
| Cardstock fins. I drilled holes for small dowels to peg into the missile rails for better security. |
