Hangar |
Aircraft |
Category |
Date |
Preview |
NATOMike | Guillows Series 800 - Stearman PT-17 | Build | 21-Jun-20 10:29 | |
Views : 1176 |
Got both outer struts on. With the one of the left I pieced together the struts properly. The ones of the right side (as seen from the front) are backwards. It was not obvious from the start, but once I saw the proper way it made sense. |
NATOMike | Guillows Series 800 - Stearman PT-17 | Parked | 21-Jun-20 10:27 | |
Views : 1023 |
Attached the upper wing by starting with the inner struts, little hard without "slots " for the rear struts |
NATOMike | Guillows Series 800 - Stearman PT-17 | Build | 15-Jun-20 12:44 | |
Views : 962 |
Finished covering with tissue. I discovered that the B5 pieces were so long I could not place the lower wing underneath the fuselage. Spent some time sanding it down. I am beginning to assemble the parts, but I am not sure the nose cone will go on easily to make it flyable. I can already sense the CG and the CM are way off. |
NATOMike | Guillows Series 800 - Stearman PT-17 | Parked | 15-Jun-20 12:42 | |
Views : 948 |
The lower wing was a serious challenge and I avoided making any control surface moveable. I originally wanted to make a flyable model, but not sure that will happen. |
NATOMike | Guillows Series 800 - Stearman PT-17 | Parked | 15-Jun-20 12:41 | |
Views : 1010 |
Started lower wing, but decided not to build diherdyl or make the aileron separate. This has been a challenge so far and I am frustrated with the complexity. I overshot with a more advanced build |
NATOMike | Guillows Series 800 - Stearman PT-17 | Parked | 15-Jun-20 12:38 | |
Views : 929 |
This is the first time I had to shape the leading edge. I used sandpaper, but should have used a knife/razor. |