|
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 21-Sep-17 21:03 |  | | Views : 697 | | Extra long stringers are glued onto the float formers with CA glue, while the float is still secure in the jig, and left to dry. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 09:28 |  | | Views : 695 | | All of the float formers are now "double white glued" into place and allowed to dry. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 09:23 |  | | Views : 664 | | The float formers are all notched and sized using a small piece of 1/16" square stringer, and are ready to glue to the open keel sides of the float. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 09:19 |  | | Views : 653 | | All of the crossmember planks are sandwiched snugly on each side of each, finished side float former, and this holds everything very securely, to provide a solid surface, of the open bare side (no formers) of the keels. This setup is extremely handy when gluing down the side formers, and pushing down on them and positioning them. It also provides a very solid base when gluing on the stringers after the formers have dried. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 09:13 |  | | Views : 437 | | The crossmember planks are then slipped in UNDER the top and bottom center keels, with the crossmember plank ends sitting ON TOP of the rails, where they are pinned in place. The Rails are just high enough to raise the side edge of the finished former side, just above the building board. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 09:12 |  | | Views : 374 | | The Rails are 1/4" X 1/2" X 12" hard stick balsa, and the Crossmembers are 1/16" X 3/8" X 3" balsa planks. The crossmembers do not slide, but are pinned down to the rails, snugly sandwiching and holding each former. |
|
