Hangar |
Aircraft |
Category |
Date |
Preview |
rayl | Scratch Built Loening OL-8 Amphibian | Build | 21-Jun-15 16:11 | |
Views : 669 |
This about where they will be when I get them mounted on the L/G, which will be wole other story. |
rayl | Scratch Built Loening OL-8 Amphibian | Build | 21-Jun-15 16:09 | |
Views : 556 |
Tire material: before and after. This a piece of vacuum hose from teh atuomotive store. You can also use foam filler rod. I cut the tubing just a LITTLE shorter than the teh circumference of the rim and used gell superglue and held it together for a minute until the CA set-up. I snaded the whole tire down with 100 grit papaer then use my Dremel tool with a coarse scotch-brite wheel to buff it all to the same appearance. |
rayl | Scratch Built Loening OL-8 Amphibian | Build | 21-Jun-15 16:03 | |
Views : 550 |
It even goes round-n-round! |
rayl | Scratch Built Loening OL-8 Amphibian | Build | 21-Jun-15 16:02 | |
Views : 585 |
All done. Note the offset of the rim holes as I mentioned earlier. |
rayl | Scratch Built Loening OL-8 Amphibian | Build | 21-Jun-15 16:01 | |
Views : 546 |
Working on the top side with the wire all tangled up. I found that you should take time to un-tangle the wire about every three holes. Also, as John O intoned, MAKE SURE that the length of the piece of the spoke material is long enough!!! (40 spokes) X (1 1/8 radius) = 50 inches. I added 10 inches for a comfort factor. |
rayl | Scratch Built Loening OL-8 Amphibian | Build | 21-Jun-15 15:57 | |
Views : 562 |
here the bottom side is done, starting on the top side. |