| Hangar |
Aircraft |
Category |
Date |
Preview |
| John M Oshust | Scratch Built Ford Tri Motor | Build | 24-Jan-08 20:50 |  |
| Views : 1102 |
| I notched all of the "wing thingies" with a dremel. I cannot make final decisions about stringers untils my styrene sheets are here. |
| John M Oshust | Scratch Built Ford Tri Motor | Build | 24-Jan-08 20:48 |  |
| Views : 1111 |
| Working W/O benifit of instructions, Uncle Carlo and I are "WingingIT" so to speak this evening. I do not need a dihedral and the ventral wing surface is flat 38 in span. |
| John M Oshust | Scratch Built Ford Tri Motor | Build | 24-Jan-08 17:19 |  |
| Views : 1137 |
| Slightly ahead of schedule the engines, bearings and props are a unit that will be installed when the remainder of the Goose is painted and assembled. As you can see I am starting the wings. |
| John M Oshust | Scratch Built Ford Tri Motor | Build | 24-Jan-08 14:20 |  |
| Views : 1253 |
| Prop finishing. The prop bearings are made. I hope to have three assembled prop and engine units this PM. |
| John M Oshust | Scratch Built Ford Tri Motor | Build | 23-Jan-08 19:34 |  |
| Views : 1137 |
| The wing plan just fits accross my board. The goose sits in the center, this whould give you some refence to final wing size. Misty, as usual, is impressed. |
| John M Oshust | Scratch Built Ford Tri Motor | Build | 23-Jan-08 19:31 |  |
| Views : 1218 |
| Further work on the engines...exhaust pipes, must wait until after final paint and engine mounting. |
