| Hangar |
Aircraft |
Category |
Date |
Preview |
| John Cooper | Guillows Series 300 - DeHavilland Beaver | Build | 23-Jan-14 13:32 |  | | Views : 1564 | | Finished, balanced and weighing in at 33.8g (1.39oz), without rubber. This is a good weight for indoor flying and may even be able to R.O.G. off a smooth floor. Unfortunately I built the float struts too short and needed to use a smaller home-build 3 blade balsa prop instead of the kit prop. |
| John Cooper | Guillows Series 300 - DeHavilland Beaver | Build | 22-Jan-14 20:30 |  | | Views : 1427 | | The struts for the floats are supported by very thin steel wire. They have quite a bit of flex and I will need this in order to land safely on a hard gym floor. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| John Cooper | Guillows Series 300 - DeHavilland Beaver | Build | 22-Jan-14 14:56 |  | | Views : 1288 | | I embellished the engine with a balsa disk with straight pins stuck into it. I trimmed the pins to just fit in the cowl. |
| John Cooper | Guillows Series 300 - DeHavilland Beaver | Build | 22-Jan-14 14:53 |  | | Views : 1243 | | I liked the fact that there are float plans in the kit - although I didn't follow the plans exactly. I only used a few bulkheads and stringers and sheeted everything with 1/32 contest balsa. They look a little heavy but weight in at a reasonable 9.2 grams. |
|
