I think all is working again now. Please leave a comment on a photo somewhere if something you need is not working still.

Main Menu
User Login
User Name
Password



View By Aircraft
Users Aircraft

Browse Images

Virtual Aerodrome Image Browser ( Small / Large ) Show : All | Parked | Flying | Build | Aerial | Reference
Page (2 in total) : [ 1 ]  2  [ Next > ]
Hangar Aircraft Category Date Preview
pfinnScratch Built MIA - Micro Indoor AircraftReference09-Jan-12 23:25
Views : 1090
The picture says it all. Very nice Vac Form parts. Lightweight silkspan is included. VERY nice kit.
pfinnScratch Built MIA - Micro Indoor AircraftReference09-Jan-12 23:22
Views : 1133
It uses a center "Beam" constuction technique. Lot's of ribs. 8o0
pfinnScratch Built MIA - Micro Indoor AircraftReference09-Jan-12 23:21
Views : 1186
That's an 18" scale. 34" WS. This is advertised as a "Display" model.
pfinnScratch Built MIA - Micro Indoor AircraftReference08-Jan-12 18:53
Views : 1088
pfinnScratch Built MIA - Micro Indoor AircraftReference08-Jan-12 18:52
Views : 1112
Scored at the AMA Expo today (not that I need any more). The Herr laser cut G-Bee and Corsair and the Comet Ryan SC and DH-4 (Jimmy's purchase) cost $60 for the "Bundle". But I was most excited to find the "Lancaster". We walked away with the other four to put them in the car, but alas, I could not resist the pull and went back and picked up the Bomber.
pfinnScratch Built MIA - Micro Indoor AircraftBuild02-Dec-11 21:59
Views : 1083
Swapped out the motor again to ParkZone gear. Note the different gear ratio (about 4/1). The motor is a much "Hotter" wind than the previous. I had to revert to a lower pitch prop because the "P Factor" (torque) of the 100x80mm would roll the aircraft over with a rapid advance of the throttle! Yikes! http://www.youtube.com/user/pfinnfp?feature=mhee .
Hangar Aircraft Category Date Preview
pfinnScratch Built MIA - Micro Indoor AircraftBuild29-Nov-11 21:16
Views : 1133
Changed the powerplant from the 7mm 1.7 ohm direct drive to a 6mm 4.5ohm 5.25:1 ratio gearbox. The prop in the picture is a 100x60 mm. It barely kept the aircraft in the air. I switched to a 100x 70 or 80? (doesn't say) for the video. Better. http://www.youtube.com/watch?v=F-Bv9zRJctY
pfinnScratch Built MIA - Micro Indoor AircraftFlying16-Oct-11 14:18
Views : 1194
The rear wing incedence needs to changed as well as CG. here's a preliminary video: http://www.youtube.com/watch?v=cuz_72JGFo8 .
pfinnScratch Built MIA - Micro Indoor AircraftFlying16-Oct-11 14:16
Views : 1202
Hooked up the RC gear and had a couple initial flights.
pfinnScratch Built MIA - Micro Indoor AircraftBuild30-Aug-11 22:32
Views : 1203
No controll surfaces yet.
pfinnScratch Built MIA - Micro Indoor AircraftBuild30-Aug-11 22:31
Views : 1173
Temporarily assembled so I could set the C of G with a few tosses (freeflight). The thing actually flies. Notice that one of the motor leads worried off. Bummer.
pfinnScratch Built MIA - Micro Indoor AircraftBuild17-Jul-11 23:57
Views : 1254
2um mylar covering. Used thinned "Stix-It" heat sensitive adhesive to apply. A bit tricky at first (as always) but gets easier with practice. Slivers of mylar trimmings REALLY do the static cling thing big time. Funny and annoying at the same time! I put some on Nico the cat. That was the funny part ;o) !
Page (2 in total) : [ 1 ]  2  [ Next > ]