I think all is working again now. Please leave a comment on a photo somewhere if something you need is not working still.

Main Menu Home About Browse images Signup Lost password? News Links Help User Login User Name Password View By Hangar View By Aircraft Guillows Series 800 - Stearman PT-17 View Details View All Switch Aircraft Users Aircraft BillParker biplane guy bubbafusion Creosotewind Dale1416 David Duckett dfrank47 Don C dovbear FLYBOYZ flyguy172 FsFalcon heywooood jgood LASTWOODSMAN lpc30 NATOMike plasticbuddha poppy R-985 rayl RTD89 Skyediamonds Skyediamonds1985 Steve_in_NH

Guillows Series 800 - Stearman PT-17 by plasticbuddha. Viewed 1082 times. Build Thread Next Prev Click image to return. Image Comments plasticbuddha 14-Aug-07 22:03 plasticbuddha 14-Aug-07 22:07 Sealed all of the cut edges with CA before sanding. Several coats of primer filler were needed. plasticbuddha 14-Aug-07 22:09 You can see the scale difference between the kit's cardboard version and the scratchbuilt one (closer to scale). JohnG. 15-Aug-07 09:39 Why did you feel the need to seal the cut edges with C/A before sanding?? poppy 15-Aug-07 10:01 Superb craftsmanship. Jedi 15-Aug-07 15:01 How are you getting the perfect cut circles? plasticbuddha 15-Aug-07 16:20 Hi John! I found out (the hard way) that some balsa sheets are prone to chipping very easily. So I rough cut the outline, run a bead of CA along where the finished edge will be and then I can sand/file/ream out with less chances of breaking out or chipping. It also stiffens and hardens the balsa so that it almost feels like styrene or plywood. poppy - Thank you! It is very flattering to recieve a complement from one of the Masters!!! Jedi - Since I don't have a MotoTool, I resorted to wrapping some sandpaper around the sharpened end of a pencil. I then reamed out the roughly punched holes. Takes a lot of time!!! (ugh!) plasticbuddha 15-Aug-07 16:44 BTW poppy, since you've finished the fabulous Hellcat, what are you working on next? moostang51 15-Aug-07 18:03 Dremel (rotary) tools are great for some things, but for uniform holes and avoid chipping and splintering, forstner bits are the best. Dremel tools are to high torque and unless you put them in a dremel drill press I forsee problems. Any wood tends to tear, because you are cutting across and with the grain at the same time. Forstner bits will put its' pilot dead center and cut and lift the wood out. Any clear through holes should be backed up any way by scrap anyway to avoid tearout. As far as bezels, since you seem to be laminating, if you would ream out the hole from the backside it would create an undercut which would allow only a small piece of the bezel to show through with no cutting or trimming necessary. Please sign in to comment on this image.