| Build Thread, Page :
[ 1 ] (11 posts, 20 posts per page, 1 pages in total)
|
|
| mark eggebeen, Comment for image # 40981 | 02 Mar 20 10:06 |
| this was my first try at finishing with card stock...It's in the category of " don't look too close"
If anyone is flying in for the Rhyder cup in Sept , stop in to say hello. |
| mark eggebeen, Comment for image # 40982 | 13 Apr 19 22:41 |
| thanks, both of you...
|
| David Duckett, Comment for image # 40981 | 13 Apr 19 21:00 |
| Same for this one. |
| David Duckett, Comment for image # 40982 | 13 Apr 19 19:14 |
| This kit is in 1/25 scale so the prop size would be 5.36" diameter. |
| kenm94591, Comment for image # 40982 | 13 Apr 19 18:39 |
| Propeller diameter is 13'2" or 134" divided by 16 (1/16 scale} is 8.375". Each blade is half of that minus the size of the hub. That may not be correct but that is how I would try to determine the size. |
| mark eggebeen, Comment for image # 40982 | 12 Apr 19 13:55 |
| can someone give me the dimensions for these prop blades ? |
| mark eggebeen, Image # 40982 | 12 Apr 19 13:53 |
\ |
| mark eggebeen, Image # 40981 | 12 Apr 19 13:52 |
|
| mark eggebeen, Image # 40941 | 24 Mar 19 23:25 |
|
| mark eggebeen, Comment for image # 40940 | 24 Mar 19 23:22 |
| I believe I've got it..... |
| mark eggebeen, Image # 40940 | 24 Mar 19 23:21 |
|
| Build Thread, Page :
[ 1 ] (11 posts, 20 posts per page, 1 pages in total)
|
|
