| Hangar |
Aircraft |
Category |
Date |
Preview |
| Dfell | Sterling Albatross DII-A | Parked | 25-Jan-21 09:04 |  |
| Views : 536 |
| At last – finished. All rigged / cockpit windscreen done plus some vents or cowl covers. The vents were 3D printed. Again thanks for looking and the comments. |
| biplane guy | Scratch Built Waco UPF-7 | Parked | 24-Jan-21 15:48 |  |
| Views : 527 |
| Controls connected and working from cockpit. |
| biplane guy | Scratch Built Waco UPF-7 | Parked | 24-Jan-21 15:47 |  |
| Views : 417 |
| WACO UPF-7 controls |
| Don C | Scratch Built Vultee BT-13 | Build | 23-Jan-21 19:17 |  |
| Views : 397 |
| Productive day, but a sore back. Wings infilled. The 2 open slots are where the landing gear are mounted. Question for everyone: My LHS closed a couple of years ago. Have to order suplies on line. The balsa I have received is very hard . Any ideas where to get good balsa? |
| Don C | Scratch Built Vultee BT-13 | Build | 22-Jan-21 18:08 |  |
| Views : 391 |
| Finally had a fair amount of time. Stringers on, diagonals removed and infill started.. Looks like it's going to work fine. |
| Don C | Scratch Built Vultee BT-13 | Build | 21-Jan-21 16:13 |  |
| Views : 356 |
| Basic fuselage pretty well done. Wings under way. $ ribs and a 1/8 inch leading edge are pretty light, so I sutci in the diagonals for a bit more strength. Starting to apply stringers. Scratched a center rib for each wing and glued it at an angle |
