Main Menu
User Login
User Name
Password

View By Hangar


View By Aircraft

Top Ten Aircraft :
(numbers in brackets represent number of images online)
Top Six Manufacturers :

Browse Images

Virtual Aerodrome Image Browser ( Small / Large ) Show : All | Parked | Flying | Build | Aerial | Reference
Page (3343 in total) :  <<   142   143   144   145   146  [ 147 ]  148   149   150   151   152   >>  [ < Prev ] [ Next > ]
Hangar Aircraft Category Date Preview
biplane guyGuillows Series 200 - SE5aParked13-May-21 07:10
Views : 4172
Rigging with Beadalon
biplane guyScratch Built Waco UPF-7Parked13-May-21 06:55
Views : 852
Passenger door
biplane guyScratch Built Waco UPF-7Parked11-May-21 12:25
Views : 817
Tail detail less rigging
biplane guyScratch Built Waco UPF-7Parked07-May-21 14:20
Views : 943
Fuselage painting done
mark eggebeenGuillows Series 2000 - PBY CatalinaParked06-May-21 22:40
Views : 1003
if this is not right ,feel free to tell me...instruction photos were a little vague
Don CScratch Built Basler BT-67Parked06-May-21 12:13
Views : 3975
So I got tired of waiting until we could drive to the east coast to deliver thiis to my son in law. Went to UPS to check. $400 to send it from Montana to Maryland.I said "No". Guess he'll just have to wait.
Hangar Aircraft Category Date Preview
bsadonkillGuillows Series 600 - Cessna 180Parked06-May-21 10:30
Views : 9031
SEE! much better.
bsadonkillGuillows Series 600 - Cessna 180Parked06-May-21 10:28
Views : 8965
A better flying 600 series Cessna, with removable nose plug and washed out wing tips.
mark eggebeenGuillows Series 2000 - PBY CatalinaBuild04-May-21 16:23
Views : 1291
lots of compound curves coming up
mark eggebeenGuillows Series 2000 - P-38 LightningBuild03-May-21 22:38
Views : 7807
getting started
edtherendermanGuillows Series 200 - Rumpler C5Build03-May-21 08:23
Views : 920
Finished modeling and 3D printing the Daimler-Mercedes D.IVa engine this week end. Had a couple of failed prints, and the print job with the cylinders took about 7 hours to run, but I did get it done. Note that the engine will be about 2.25” fully built. I also modeled in a spinning prop shaft, so if all goes well, I can put on a prop that will turn relatively easily. We shall see. (I think it’s time I find a new parts cutting board to photograph my part on! This one has seen better days!)
BriandKilbyGuillows Series 500 - FW 190Build01-May-21 15:50
Views : 925
light blue underside.
Page (3343 in total) :  <<   142   143   144   145   146  [ 147 ]  148   149   150   151   152   >>  [ < Prev ] [ Next > ]
(c) 2010 www.VirtualAerodrome.com / James Good. All pictures are property of the individual members of this site.
They may not be used without permission from the user.