| Hangar |
Aircraft |
Category |
Date |
Preview |
| edbecky | Peck Polymers A6M Zero | Build | 02-Mar-20 16:22 |  | | Views : 679 | | I'm gonna say finished and go back to work on the B25 Mitchell.. |
| edbecky | Peck Polymers A6M Zero | Build | 02-Mar-20 16:20 |  | | Views : 599 | |
| edtherenderman | Aero-Werkes AW 11601 - Hannover CL IIIa | Build | 02-Mar-20 08:46 |  | | Views : 339 | | Not a lot of building going on right now. Was down with the flu last week (nope, not Corvid-19 although I live just north of Kirkland, WA!). I did spend a good bit of time refining the pipeline for using the laser etcher and found a couple of good shortcuts. I’m planning on putting together a how-to for those who are interested. Anyway, here is a picture of the upper and lower wings for the Hannover. The center section of the upper wing was sheeted in the original a/c and contained an aux fuel tank and radiator. I’m going to 3D model and print those parts. I’ve also spend a week (prior to the flu) modeling the interior details so I can print them. I still need to model the engine. Once I get all the parts done, I’ll fit them to the fuse before sheeting. Finally, I spent some time sheeting, filling and sanding the vertical fin and lower horz stab (no pictures yet). These were integral parts of the original a/c fuse, so wanted to get them sheeted before mounting them and sheeting the fuse. |
| biplane guy | Guillows Series 200 - SE5a | Parked | 01-Mar-20 19:37 |  | | Views : 964 | | Finished cockpit |
| edbecky | Peck Polymers A6M Zero | Build | 27-Feb-20 15:44 |  | | Views : 685 | | Next step prop. |
| Don C | Scratch Built Basler BT-67 | Build | 25-Feb-20 17:58 |  | | Views : 431 | | Glue worked well and the turbo props fit. |
|
|
