Browse Images

Virtual Aerodrome Image Browser ( Small / Large )

Hangar	Aircraft	Category	Date	Preview
jkap5	Guillows 1903 Wright Flyer	Build	11-Jun-07 18:51
Views : 1968
Here is Orville on his pilot rests. The kit comes with picture cutouts to glue on. I'm not sure if I want to use those though.
jkap5	Guillows 1903 Wright Flyer	Build	11-Jun-07 18:49
Views : 1819
Here are the fuselage pieces. The ones that look like L's go on the outside and the other ones go on the inside.
jkap5	Guillows 1903 Wright Flyer	Build	11-Jun-07 18:47
Views : 1910
These are the rudder struts. The skinny one goes on top and the wider one goes on bottom.
jkap5	Guillows 1903 Wright Flyer	Build	11-Jun-07 18:45
Views : 1971
Here are all of the painted mechanics. Engine, pullies, and pully belts.
jerry campbell	Dave Diels Engineering, Inc Kit #43, Ki 84 Hayate "Frank"	Build	10-Jun-07 22:45
Views : 1402
I added balsa filets on the wing tips rather than the stringers the plans called for. I think they look far better than stringes and paper.
jerry campbell	Dave Diels Engineering, Inc Kit #43, Ki 84 Hayate "Frank"	Build	10-Jun-07 22:39
Views : 1410
Fit is snug and with a little trimming/sanding the fit should be almost perfect.

Hangar	Aircraft	Category	Date	Preview
jerry campbell	Dave Diels Engineering, Inc Kit #43, Ki 84 Hayate "Frank"	Build	10-Jun-07 22:31
Views : 1373
The fuselage and wings are built. I added stringers around the cockpit and on the top side of the wing. The center section of the wing was hard to follow the instructions, but was finally together.
mattolson	Guillows Series 400 - Spitfire	Build	10-Jun-07 19:34
Views : 5176
Paint in progress.
mattolson	Guillows Series 400 - Spitfire	Build	10-Jun-07 19:32
Views : 5381
Paint in progress.
mattolson	Guillows Series 400 - Spitfire	Build	10-Jun-07 19:31
Views : 5217
Paint in progress.
mattolson	Guillows Series 400 - Spitfire	Build	10-Jun-07 19:30
Views : 5369
Painting in progress. Am learning how to use the airbrush. It will require some practice, but I like the airbrush look.
moostang51	Guillows Series 2000 - B-24 Liberator	Build	10-Jun-07 18:10
Views : 2147
Whatever is on the plane has been prepped for covering. Had a little issue with the shaping of the right rudder. The rudder construction on this plane proved to be quite a challenge since it will be moveable. Cosidered carving it out of 3/8 solid stock bu

All pictures are property of the individual members of this site.
They may not be used without permission from the user.