| Hangar |
Aircraft |
Category |
Date |
Preview |
| Don C | Comet Corsair | Build | 10-Dec-15 00:29 |  |
| Views : 1073 |
| Working on IFF |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 09-Dec-15 16:30 |  |
| Views : 917 |
| Finished Vickers machine gun ready for action |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 09-Dec-15 16:21 |  |
| Views : 1019 |
| I dipped a small paint brush into silver pain and dabbed it onto a paper towel until it was almost dry and then dry-brushed onto the stock accessories to give them some highlights. |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 09-Dec-15 16:16 |  |
| Views : 885 |
| Cutting up some small accessories to the stock portion of the gun. |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 09-Dec-15 16:12 |  |
| Views : 847 |
| Stock of the gun. The hole is when I accidentally pushed the pin too far in my attempts to simulate rivets. this is okay, since this part will be hidden. I apologize for the slightly blurry image. |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 09-Dec-15 16:07 |  |
| Views : 921 |
| Using my best guess (eyeballing), I figured the stock to the gun would be about j"just so big" and cut a block of balsa wood. Used left over plastic cut and scored to shape the stock. Then used a pin to push out some rivets. |
