| Image Comments |
| David Duckett | 19-Jan-12 15:13 |
| The formers are mounted on a "beam" of 1/8" balsa, not this stick, and the stringers are then glued in place. I'll be cutting the center slot in the formers inside the printed lines and trimming to fit with the xacto blade. |
| frwyflyer | 19-Jan-12 16:54 |
| Is the beam "stepped' for location of the formers? |
| David Duckett | 19-Jan-12 20:35 |
| The beams are marked with former locations. |
| John M Oshust | 19-Jan-12 22:11 |
| Could you use say 8 notched stringers to hold the formers on the beam. Remove all of the other notches and former material to a depth of 1/8 in, then plank the remainder with stringers? Maybe then you would not have to fill the spaces between all of the stringers. |
| David Duckett | 20-Jan-12 06:28 |
| I see no reason to re-engineer the kit. |
| John M Oshust | 20-Jan-12 06:53 |
| Figured you could avoid the small piece filling work. |
| jerry campbell | 20-Jan-12 08:52 |
| Dave could you show the plans? |
| John M Oshust | 21-Jan-12 10:14 |
| Sloppy service from Easy Built? |
