| Hangar |
Aircraft |
Category |
Date |
Preview |
| John M Oshust | ManzanoLaser Royal Aircraft Factory B.E.12a | Parked | 11-Mar-15 19:19 |  |
| Views : 1044 |
| In an attempt at making chicken salad from chicken sheet, we will address the Lewis gun mounting. |
| John M Oshust | ManzanoLaser Royal Aircraft Factory B.E.12a | Parked | 11-Mar-15 19:18 |  |
| Views : 988 |
| Gumby prepares the center upper plane section for finishing tomorrow. |
| rayl | Scratch Built Consolidated XF-92A | Build | 11-Mar-15 10:31 |  |
| Views : 1101 |
| Test fit on the plane. Not bad if I say so myself. Note to self: CA doesn't stick well to the Coke bottle plastic, use 5-56 canopy glue. |
| rayl | Scratch Built Consolidated XF-92A | Build | 11-Mar-15 10:29 |  |
| Views : 1024 |
| Close-up of the assembly. |
| rayl | Scratch Built Consolidated XF-92A | Build | 11-Mar-15 10:28 |  |
| Views : 941 |
| Not as deep as John O's workbench. After about four tries at trying to get the bent lams into the correct place, (upper right of picture), I had a"Duh" moment and realised that it would be better to set the bows on the canopy base plate, then sand them to fit the canaopy. That worked much better. I filled in the aft canopy fairing with Duram's water putty as I will need to drill some holes in it for some sort of fittings that are evident on the pictures of that area. |
| rayl | Scratch Built Consolidated XF-92A | Build | 11-Mar-15 10:20 |  |
| Views : 942 |
| Starting to figure out how to do the canopy. Coke bottle canopy and 1/32" Bass laminated over forms that were lifted off of the canopy master. I used soft Plumbers solder to duplicate the the cross-sections to transfer to my bending forms. Soaked the Bass in warm water for about 10 minutes, clamped them to the forms then popped them into the oven at 180 deg. F for about 20 minutes to dry out the bass. Worked great. |
