| Hangar |
Aircraft |
Category |
Date |
Preview |
| BriandKilby | Guillows Series 200 - Fokker DR-1 Triplane | Parked | 31-Mar-22 11:34 |  |
| Views : 1111 |
| rainbow- good fish, not as plentiful as previous years. |
| edtherenderman | Cleveland Westland Whirlwind | Build | 30-Mar-22 11:23 |  |
| Views : 4001 |
| 3D designed and printed the nose cone. Big holes for four 20MM cannons to stick out of. Lots of punch for a mid-1930’s British aircraft design! |
| edtherenderman | Cleveland Westland Whirlwind | Build | 30-Mar-22 11:21 |  |
| Views : 4002 |
| Here is the tailwheel, which also retracts. Much simpler process here. Simple horizontal pivot. Wheel and yoke assemble was created in 3D and printed using my FDM 3D printer. |
| edtherenderman | Cleveland Westland Whirlwind | Build | 30-Mar-22 11:21 |  |
| Views : 722 |
| Gear fully retracted in the Nacelle. Looking down into the top of the nacelle. |
| edtherenderman | Cleveland Westland Whirlwind | Build | 30-Mar-22 11:20 |  |
| Views : 666 |
| Gear doors closed. Doors where created using the piece cut out of the nacelle as a buck, then vacuum formed styrene over the buck. The styrene was supper thin and flexible, so I built up the insides with many layers of tissue and EZ-Dope. The outsides where filled with spackling compound, sounded, tissued, doped and painted with sanding primer. I still need to add small magnets to keep the doors together when closed. |
| edtherenderman | Cleveland Westland Whirlwind | Build | 30-Mar-22 11:19 |  |
| Views : 650 |
| Inside of nacelle looking down. You can see the hinges for the gear doors. The tee pins will be replaced with hinge pins before installing the nacelle on the wing. |
