| Hangar |
Aircraft |
Category |
Date |
Preview |
| peregrin | Dumas Kit #202, Piper J4-E Cub-Coupe | Parked | 24-Mar-13 07:58 |  |
| Views : 1097 |
| finished more or less. I might oughta try a smaller prop though |
| David Duckett | Guillows Series 2000 - B-29 Super Fortress | Build | 24-Mar-13 07:31 |  |
| Views : 1361 |
| I drew on a centerline LIGHTLY with a pencil and measured where things should be. Then I used one of the plastic bomb bay doors from the kit as a template to draw on the doors.Next I used a regular piece of paper, which has perfect 90* angles, with one edge taped on the centerline to establish where the line going around the fuselage is.I marked lightly with lencil about three guide marks and then used a piece of flexible plastic to draw on the line. Lines. With these lines as reference the ones remaining to be added will be easier to establish. |
| John M Oshust | ManzanoLaser Ansaldo A.1 Balilla | Build | 23-Mar-13 13:19 |  |
| Views : 950 |
| Progress on Nunzio's air foils. |
| David Duckett | Guillows Series 2000 - B-29 Super Fortress | Build | 21-Mar-13 21:32 |  |
| Views : 1394 |
| My helper holds the wing down while the CA sets up..... |
| David Duckett | Guillows Series 2000 - B-29 Super Fortress | Build | 21-Mar-13 21:30 |  |
| Views : 1372 |
| The landing gear doors were cut from the bottom engine nacelle before it was assembled. To reattach I "hung" them with a short piece of masking tape taped to the backside of the door and that allows enough support so the door can then be braced a bit with a finger inside the nacelle while a small amount of CA is applied to the junction. As soon as it cures enough to hold by itself a short piece of styrene rod was laid on the junction. The CA is still wet enough to hold the rod in place but I gave it an overall application just to make sure. You can see how it blends in. I've used this method before and I would prefer to hide the rod but this time I couldn't. |
| David Duckett | Guillows Series 2000 - B-29 Super Fortress | Build | 21-Mar-13 10:16 |  |
| Views : 1291 |
| Styrene rod glued to junction of landing gear door and engine nacelle |
