| Hangar |
Aircraft |
Category |
Date |
Preview |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 08-Feb-16 13:20 |  |
| Views : 783 |
| Then it was glued such that the painted glossy side was facing in towards the cockpit interior. I folded the edges on either side and left the center piece alone to simulate attachment to the vertical support |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 08-Feb-16 13:18 |  |
| Views : 807 |
| The paper was cut along the sides bracketing the vertical support. Punched a few "lightening" holes, and painted overall flat black. I made sure to paint along the edges to avoid the white paper showing through. |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Build | 08-Feb-16 13:14 |  |
| Views : 909 |
| To simulate the brackets and rigging inside the cockpit, I first cut some pieces of paper that is also glossy on one side. Then matched it up with my intended cockpit wooden supports. |
| David Duckett | Berkeley Douglas F4D Skyray | Build | 08-Feb-16 03:32 |  |
| Views : 990 |
| Ready to start the covering process |
| David Duckett | Berkeley Douglas F4D Skyray | Build | 08-Feb-16 03:31 |  |
| Views : 1002 |
| The fin/rudder was glued on first with Testors and then CA. |
| Skyediamonds1985 | Guillows Series 200 - SE5a | Parked | 07-Feb-16 14:47 |  |
| Views : 830 |
| I twisted the sheave to help give you an idea of the small size and groove. According to the BlueJacket catalogue, these two accessories are cast in "Britannia Metal." |
