Main Menu
User Login
User Name
Password

View By Hangar


View By Aircraft

Top Ten Aircraft :
(numbers in brackets represent number of images online)
Top Six Manufacturers :

Browse Images

Virtual Aerodrome Image Browser ( Small / Large ) Show : All | Parked | Flying | Build | Aerial | Reference
Page (29 in total) :  <<   6   7   8   9   10  [ 11 ]  12   13   14   15   16   >>  [ < Prev ] [ Next > ]
Hangar Aircraft Category Date Preview
edtherendermanGuillows Series 200 - Rumpler C5Build20-Jun-21 19:30
Views : 413
edtherendermanGuillows Series 200 - Rumpler C5Build20-Jun-21 19:30
Views : 488
edtherendermanGuillows Series 200 - Rumpler C5Build20-Jun-21 19:29
Views : 388
More work this weekend. Engine done.
edtherendermanGuillows Series 200 - Rumpler C5Build07-Jun-21 13:51
Views : 348
edtherendermanGuillows Series 200 - Rumpler C5Build07-Jun-21 13:48
Views : 366
Image of 3D parts in Blender.org
edtherendermanGuillows Series 200 - Rumpler C5Build07-Jun-21 10:09
Views : 352
Been very busy 3D modeling and printing parts. Also, lots of modifications to the fuse to accept the new cockpit covers and all the added interior detail. Starting to assemble and paint the plastic parts now. Again, Wingnut Wings (http://www.wingnutwings.com/ww/) has been an amazing resource! If you are building WW1 models, check out their site! Pictures of both the original aircraft and the models are amazing. I've not bought one of their models yet, but they must be amazing!
Hangar Aircraft Category Date Preview
edtherendermanGuillows Series 200 - Rumpler C5Build07-Jun-21 10:05
Views : 408
Been quite on the Rumpler, but still working on it. Now have everything but the fuse covered and doped to high sheen.
edtherendermanGuillows Series 200 - Rumpler C5Build03-May-21 08:23
Views : 530
Finished modeling and 3D printing the Daimler-Mercedes D.IVa engine this week end. Had a couple of failed prints, and the print job with the cylinders took about 7 hours to run, but I did get it done. Note that the engine will be about 2.25” fully built. I also modeled in a spinning prop shaft, so if all goes well, I can put on a prop that will turn relatively easily. We shall see. (I think it’s time I find a new parts cutting board to photograph my part on! This one has seen better days!)
edtherendermanGuillows Series 200 - Rumpler C5Build25-Apr-21 19:19
Views : 585
edtherendermanGuillows Series 200 - Rumpler C5Build25-Apr-21 19:19
Views : 555
edtherendermanGuillows Series 200 - Rumpler C5Build25-Apr-21 19:18
Views : 426
edtherendermanGuillows Series 200 - Rumpler C5Build25-Apr-21 19:18
Views : 646
Working on framing the Rumpler. Pretty much done now. Next is 3D modeling cockpit details, then tissue covering.
Page (29 in total) :  <<   6   7   8   9   10  [ 11 ]  12   13   14   15   16   >>  [ < Prev ] [ Next > ]
(c) 2010 www.VirtualAerodrome.com / James Good. All pictures are property of the individual members of this site.
They may not be used without permission from the user.