| Hangar |
Aircraft |
Category |
Date |
Preview |
| David Duckett | Dumas Kit #503, Boeing AV 8B Harrier | Reference | 02-Dec-09 10:57 |  | | Views : 701 | | The two parts have been shaken and then allowed to sit for a minute or so. I poured in 1/2 oz of part A and then 1/2 oz of part B and have gently stirred the mixture with the stick and it still has a slightly milky look but that's OK. Instructions are included with the resin. The idea here is to get rid of all the tiny bubbles. |
| David Duckett | Dumas Kit #503, Boeing AV 8B Harrier | Reference | 02-Dec-09 10:52 |  | | Views : 732 | | Step 1. Spray the inside of the pieces with the release agent and then wipe it with the soft brush. Spray again and let sit 5 minutes before using. NOTICE: The blue plastic covering the clear part has NOT been removed. |
| David Duckett | Dumas Kit #503, Boeing AV 8B Harrier | Reference | 02-Dec-09 10:49 |  | | Views : 889 | | Materials: The resin set is #82057, CR-600 Casting Resin - $32.95. The release agent is #82664 Rubber To Resin Mold Release- $17.50. Mixing cups, a stick to stir it , and a soft brush are needed, as well. The plastice pieces are from Guillows and Dumas kits. |
| David Duckett | Dumas Kit #503, Boeing AV 8B Harrier | Reference | 02-Dec-09 10:44 |  | | Views : 799 | | As per your request...Micromark.com has lots of goodies for modelers. This is part of the casting stuff and there's more but this has what I use. Following is a "how to" on using the stuff to make casts from the plastic pieces in typical balsa and tissue kit. Perhaps James can put it in the official place...:-) |
| David Duckett | Dumas Kit #503, Boeing AV 8B Harrier | Build | 01-Dec-09 12:28 |  | | Views : 759 | |
| David Duckett | Dumas Kit #503, Boeing AV 8B Harrier | Build | 30-Nov-09 19:57 |  | | Views : 798 | | The rear exhaust |
|
|
