I think all is working again now. Please leave a comment on a photo somewhere if something you need is not working still.

Main Menu
User Login
User Name
Password



View By Aircraft

Top Ten Aircraft :
(numbers in brackets represent number of images online)
Top Six Manufacturers :

Browse Images

Virtual Aerodrome Image Browser ( Small / Large ) Show : All | Parked | Flying | Build | Aerial | Reference
Page (98 in total) :  <<   64   65   66   67   68   69   70   71   72   73   74   >>  [ < Prev ] [ Next > ]
Hangar Aircraft Category Date Preview
jgoodGuillows Series 700 - Fairchild 24Build31-Aug-05 23:19
Views : 1359
More covering completed.
jgoodGuillows Series 700 - Fairchild 24Build30-Aug-05 08:10
Views : 1509
jgoodGuillows Series 700 - Fairchild 24Build30-Aug-05 08:09
Views : 1399
You can just see the little supports where the strut wire enters the covering and into the fuselage.
jgoodGuillows Series 700 - Fairchild 24Build30-Aug-05 08:08
Views : 1627
Detail of the struts thread wrapped to the support wire that goes through the fuselage.
jgoodGuillows Series 700 - Fairchild 24Build29-Aug-05 23:27
Views : 1692
jgoodGuillows Series 700 - Fairchild 24Build29-Aug-05 23:05
Views : 1389
Wings attached now. Not sure I've got the order of assembly right (looks like it's going to be tough to cover the top fuse now).
Hangar Aircraft Category Date Preview
jgoodGuillows Series 700 - Fairchild 24All28-Aug-05 18:57
Views : 1252
Fuselage half covered, tail plane and fin now permanently attached.
jgoodGuillows Series 700 - Fairchild 24All28-Aug-05 18:57
Views : 1259
jgoodGuillows Series 700 - Fairchild 24All28-Aug-05 18:56
Views : 1907
Electronics installed, control linkages hooked up, and elevator and rudder covered.
jgoodGuillows Series 700 - Fairchild 24All28-Aug-05 18:55
Views : 1313
Shadow.
jgoodGuillows Series 700 - Fairchild 24Build26-Aug-05 20:30
Views : 1615
LPS drive mounted in the nose. You can see the two plastic spacers made from a ball-point pen insert.
jgoodGuillows Series 700 - Fairchild 24Build26-Aug-05 20:29
Views : 1548
Detail of the installation of the LPS drive unit. One piece of lite ply was CA'd to the bulkhead, and the second is a spacer (not glued). The motor is then screwed to the CA'd lite ply piece using the bottom two screws only. The top just has spacers (no s
Page (98 in total) :  <<   64   65   66   67   68   69   70   71   72   73   74   >>  [ < Prev ] [ Next > ]