Hangar |
Aircraft |
Category |
Date |
Preview |
Don C | Scratch Built Vultee BT-13 | Build | 22-Nov-21 16:16 | ![](user_aircraft_thumb100/43612.jpg) |
Views : 263 |
These are the lenses for the landing lights. |
Don C | Scratch Built Vultee BT-13 | Build | 22-Nov-21 16:15 | ![](user_aircraft_thumb100/43611.jpg) |
Views : 325 |
Finally finished all control surface actuatios and main gear |
Don C | Scratch Built Vultee BT-13 | Build | 10-Nov-21 21:24 | ![](user_aircraft_thumb100/43597.jpg) |
Views : 270 |
This should be 1st . ready to go. Oven heated to 280. Let it heat for about 5 minutes, then move quickly. If it doesn't go all the way down over the mold, back in the oven for a longer time. It will flatten out and give you a second chance.. |
Don C | Scratch Built Vultee BT-13 | Build | 10-Nov-21 21:18 | ![](user_aircraft_thumb100/43596.jpg) |
Views : 273 |
Its helpful to mark where to cut before removing it from the form. I made 2 in case I messone up fitting or painting. |
Don C | Scratch Built Vultee BT-13 | Build | 10-Nov-21 21:15 | ![](user_aircraft_thumb100/43595.jpg) |
Views : 295 |
Cooled . Haad ro work a bit to get it off the form |
Don C | Scratch Built Vultee BT-13 | Build | 06-Nov-21 20:38 | ![](user_aircraft_thumb100/43588.jpg) |
Views : 286 |
Center is fairly easy. Always redrawing lines to keep a center. Hope this help[s, Ed. |