| Hangar |
Aircraft |
Category |
Date |
Preview |
| David Duckett | Dave Diels Engineering, Inc Kit #29 Hawker Typhoon Mk 1B | Build | 18-Mar-15 05:22 |  | | Views : 439 | |
| David Duckett | Dave Diels Engineering, Inc Kit #29 Hawker Typhoon Mk 1B | Build | 18-Mar-15 05:22 |  | | Views : 436 | | The bottom was covered with three pieces. |
| David Duckett | Dave Diels Engineering, Inc Kit #29 Hawker Typhoon Mk 1B | Build | 18-Mar-15 05:21 |  | | Views : 453 | | When it dries I used 220 wet/dry sandpaper to sand away the excess silkspan. The sanding block is also used for the same purpose. Each side required two pieces. |
| David Duckett | Dave Diels Engineering, Inc Kit #29 Hawker Typhoon Mk 1B | Build | 18-Mar-15 05:18 |  | | Views : 503 | | Outside surrounded by large cardboard boxes from Amazon which contained large canvases.....The entire structure has several coats of nitrate dope on it and is quite smooth enough but I want this one covered. Dip the silkspan in the water, lay it on the towel, wipe it slightly to remove excess water, lay it down, smooth it out, and paint dope all over it. Absolutely guaranteed not to deform the wood! :-) |
| David Duckett | Dave Diels Engineering, Inc Kit #29 Hawker Typhoon Mk 1B | Build | 18-Mar-15 05:12 |  | | Views : 516 | | Back to the Typhoon... |
| David Duckett | Dave Diels Engineering, Inc Kit #29 Hawker Typhoon Mk 1B | Build | 02-Dec-14 18:32 |  | | Views : 576 | | The fin/rudder needs an application of filler before being glued in place. |
|
|
