| Image Comments |
| hjlittman | 29-Mar-12 17:57 | | Cylinder assemblies with Uhu styrofoam glue. It's a contact rubber cement. Apply to both sides, let dry 10 minutes, press together. |
| frwyflyer | 29-Mar-12 18:14 | | VERY INTERESTING!! |
| frwyflyer | 30-Mar-12 10:15 | | Question?? Do you fill the cylinder with a balsa dowel for rigidity? My experience with rubber power a little weight in the nose isn't bad. |
| hjlittman | 30-Mar-12 11:41 | | Just a little balsa disk to increase the gluing surface. In this case, since the it is not a complete engine, just the cylinders sticking out of the cowling, and nose is tapered sharply, the front cylinders are longer than the rear ones and the bases are cut at an angle to keep the cylinder heads at the same level. (See the photo of the test fit to the nose.) |
|
|
Please sign in to comment on this image.
|
|
