| Image Comments |
| LASTWOODSMAN | 04-Feb-17 12:46 | | Here is that tool (upper right - shiny pin at the tip of a toothpic) making a pin hole into the balsa hub. Then I pushed the long sharp point, of a stained finished toothpic spoke, through the felloe hole of the wheel rim, and into the starter pin hole in the hub, twisting and spinning the spoke into the hub pin hole. I then removed the spoke and cut a little bit off of the pointy tip of the toothpic spoke, stuck it back in, pushed it into the enlarged hub hole, and spinned it nice and tight, and glued the rim felloe hole with the toothpic in it with super thin CA glue. |
|
|
Please sign in to comment on this image.
|
|
