Main Menu
User Login
View By Aircraft
Users Aircraft
|
Build Thread, Page :
1 [ 2 ] (38 posts, 20 posts per page, 2 pages in total)
|
[ < Prev ] |
NATOMike, Image # 42272 | 15 Jun 20 12:42 | The lower wing was a serious challenge and I avoided making any control surface moveable. I originally wanted to make a flyable model, but not sure that will happen. |
NATOMike, Image # 42271 | 15 Jun 20 12:41 | Started lower wing, but decided not to build diherdyl or make the aileron separate. This has been a challenge so far and I am frustrated with the complexity. I overshot with a more advanced build |
NATOMike, Image # 42270 | 15 Jun 20 12:38 | This is the first time I had to shape the leading edge. I used sandpaper, but should have used a knife/razor. |
NATOMike, Image # 42269 | 15 Jun 20 12:37 | Finally catching up with the pictures. Upper Wing done |
edbecky, Comment for image # 42175 | 17 May 20 09:36 | Looks nice! That camera angle really makes the 28" wings look big. I'm planning on doing the Sopwith Camel next so I'm watching this build. |
NATOMike, Image # 42175 | 16 May 20 13:37 | Very busy few weeks, ut I was able to buckle down and get this completed. The Wing are okay, but my next step is to put a dihedral in the lower wing |
NATOMike, Image # 42174 | 16 May 20 13:35 | Finally, after a few busy weeks at work i was able finish the two wing |
heywooood, Comment for image # 42074 | 25 Apr 20 10:25 | The gear wires are easy to work around as Don has said. No worries. Your fuselage assembly looks very clean ! Nice work there |
Don C, Comment for image # 42074 | 25 Apr 20 10:18 | The gear isn't too bad to work around. Nice straight frame there.
|
NATOMike, Image # 42074 | 25 Apr 20 10:07 | Since I had already attached the landing gear, it was easier to use a clip like this. Not sure if gluing the landing gear early will come back to haunt me later. |
NATOMike, Image # 42073 | 25 Apr 20 10:04 | Now I need to move onto the "L" Parts |
NATOMike, Image # 42072 | 25 Apr 20 10:03 | Hard to use warm water to get the stringers in place,. |
edbecky, Comment for image # 42052 | 19 Apr 20 10:08 | I think your progression is fine. Need to glue landing struts before stringers and covering. Looks good. |
NATOMike, Image # 42052 | 17 Apr 20 13:47 | Both sides and landing struts. I read the instructions and it says to glue these after step 3 in the instructions, but not which set of steps. Work has been busy, but I am continuing to work on this model |
NATOMike, Image # 42051 | 17 Apr 20 13:46 | Both sides and landing strruts |
NATOMike, Image # 42030 | 13 Apr 20 08:33 | My next attempt at a Bi-Plane,. |
NATOMike, Image # 42029 | 13 Apr 20 08:32 |
|
NATOMike, Image # 42028 | 13 Apr 20 08:31 | Starting first side |
Build Thread, Page :
1 [ 2 ] (38 posts, 20 posts per page, 2 pages in total)
|
[ < Prev ] |
|