Build Thread, Page :
1 2 3 4 [ 5 ] (92 posts, 20 posts per page, 5 pages in total)
|
[ < Prev ] |
edtherenderman, Image # 41224 | 31 Jul 19 15:23 |
Aircraft assembled without fairings |
edtherenderman, Image # 41223 | 31 Jul 19 15:21 |
Aircraft after covering. I used the same materials to cover this as I did my Sea Fury; Top Flight Silk Span and doped with Eze Dope. |
edtherenderman, Image # 41222 | 31 Jul 19 15:18 |
Top of wing. Standard construction techniques. One center section, and two wing outer sections with dihedral on the rib where landing gear attaches. Very straight forward construction. |
edtherenderman, Image # 41221 | 31 Jul 19 15:16 |
Rudder/Fin and Elevator/Stabilizer. The plans call for a single 1/16” layer, but I built up the surfaces to give them a more scale look. |
edtherenderman, Image # 41220 | 31 Jul 19 15:14 |
Fuse built. Standard construction technique with one half of the fuse on a board, laying up ribs and stringers, then removing and doing the other half. Radiator and front engine cowling is shaped balsa blocks. Note that the bottom of fuse is not completed until wing is attached. |
edtherenderman, Image # 41219 | 31 Jul 19 15:11 |
|
edtherenderman, Image # 41218 | 31 Jul 19 15:10 |
|
edtherenderman, Image # 41217 | 31 Jul 19 15:08 |
|
edtherenderman, Image # 41216 | 31 Jul 19 15:07 |
|
edtherenderman, Image # 41215 | 31 Jul 19 15:07 |
|
edtherenderman, Image # 41214 | 31 Jul 19 15:06 |
|
edtherenderman, Image # 41213 | 31 Jul 19 15:05 |
The site owner added the West Wings Hawker Tempest, so I’m starting to upload pictures I have taken since I started this last fall. Starting with pictures of the box, parts, balsa and print quality and plans. |
Build Thread, Page :
1 2 3 4 [ 5 ] (92 posts, 20 posts per page, 5 pages in total)
|
[ < Prev ] |