| Hangar |
Aircraft |
Category |
Date |
Preview |
| SteveM | Peck Polymers One Nite 28 | Flying | 08-Mar-08 18:36 |  | | Views : 717 | | These flights are all done with hand winding as the winder broke and CA wouldn't hold it together. I managed to get some 15-20 second flights and then decided my poor wrist and finger were tired of winding and it was time for electric FF conversion. |
| SteveM | Peck Polymers One Nite 28 | Flying | 08-Mar-08 18:33 |  | | Views : 712 | | Went to the park today and tried the One Nite 28 with rubber powered FF. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| SteveM | Peck Polymers One Nite 28 | Build | 07-Mar-08 15:46 |  | | Views : 780 | | I have been weighing my battery options. The KP-01 motor needs 3.6 volts while the RC receiver will need 4.8-6 volts. The LiPo is 4.4g, NiCd pack is 24.8 g, and NiMh pack is 34.1g. I either need to use two battery packs build a regulator for the motor. |
| SteveM | Peck Polymers One Nite 28 | Build | 06-Mar-08 13:01 |  | | Views : 736 | | Made in China? Nope, soldered right here in the USA with pride and not quite enough solder (note the orange wire). It's a Pixie-7P that I was going to use to provide some sort of motor control when I convert the One Nite 28 to electric RC. |
|
