| Hangar |
Aircraft |
Category |
Date |
Preview |
| SteveM | Peck Polymers One Nite 28 | Build | 08-Mar-08 23:15 |  | | Views : 824 | | KP-01 motor is retained with three 2-56 nylon screws. The holes were drilled and taped, a little thin CA wicked into the wood, then taped again. |
| SteveM | Peck Polymers One Nite 28 | Build | 08-Mar-08 23:13 |  | | Views : 807 | | 3x110 mAh NiCd and 5 amp fuse (goes into the yellow socket) acts as a switch. Fuselage also had 4" cut off of the front. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| SteveM | Peck Polymers One Nite 28 | Flying | 08-Mar-08 18:36 |  | | Views : 719 | | These flights are all done with hand winding as the winder broke and CA wouldn't hold it together. I managed to get some 15-20 second flights and then decided my poor wrist and finger were tired of winding and it was time for electric FF conversion. |
| SteveM | Peck Polymers One Nite 28 | Flying | 08-Mar-08 18:33 |  | | Views : 713 | | Went to the park today and tried the One Nite 28 with rubber powered FF. |
|
