| Hangar |
Aircraft |
Category |
Date |
Preview |
| poppy | Dumas Kit #329, Skyraider AI-E | Build | 18-Jun-12 01:30 |  | | Views : 551 | | Use a good grade 1/32" sheet balsa. cut to fit inside leading edge and overlapping trailing edge by 1/4", apply glue to l/e and pin sheet in place. Let dry about 30 min. |
| poppy | Dumas Kit #329, Skyraider AI-E | Build | 16-Jun-12 11:08 |  | | Views : 535 | | Pinning the leading edge, I again glue the edge from the top. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| poppy | Dumas Kit #329, Skyraider AI-E | Build | 16-Jun-12 11:06 |  | | Views : 478 | | Pinning at trailing edge and each extra strip, also at tip, I glue all edges from the top, leaving the leading edge till last after all have dried. |
| poppy | Dumas Kit #329, Skyraider AI-E | Build | 16-Jun-12 11:04 |  | | Views : 429 | | 3 1/16 X 1/8 stringers glued to top of lower ribs ending at rib 6. This will give a curved airfoil on bottom. Ending stringers at rib 6 allows 1/16 sheet to flatten out at tips. |
|
