| Hangar |
Aircraft |
Category |
Date |
Preview |
| edtherenderman | Scratch Built Bugatti 100P | Build | 12-Dec-21 19:54 |  | | Views : 169 | | Put a couple of solid weekends into the Bugatti. This weekend was spent sanding (more on that later) and working on the landing gear. This picture is the gear retracted with the lower covers closed. I 3D printed the covers, wheels and wheel trunnions. Hydraulics are done with copper tubing and paper wrapped and glued with CA. |
| edtherenderman | Scratch Built Bugatti 100P | Flying | 14-Nov-21 19:49 |  | | Views : 233 | | This is the buck for heat forming the canopy. 3D modeled and printed on FDM printer with Polysmooth. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| edtherenderman | Scratch Built Bugatti 100P | Build | 14-Nov-21 19:47 |  | | Views : 225 | | 3D modeled and printed the spinners and propellers. These are just press fitted at this point and still have some fitting to do, but the results look good. Spinners were done with my FDM printer using Polysmooth filament. The propellers were done with my SLA printer. |
| edtherenderman | Scratch Built Bugatti 100P | Build | 14-Nov-21 19:45 |  | | Views : 216 | | Port side exhaust fairing for back engine and cooling air outlet on trailing edge of wing. |
|
