Hangar |
Aircraft |
Category |
Date |
Preview |
Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 03-Jul-15 20:52 | | Views : 567 | This photo is only for illustrated purposes as the elongated ring would have been slipped over the balsa support before gluing onto the top of the upper cylinder half. |
Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 03-Jul-15 20:49 | | Views : 498 | This may seem a bit out of sequence, but just using a pin vise over a previously set hole from the use of a T pin, at an apprx. angle to the "V" for the extra cooling fins and support. |
|
Hangar |
Aircraft |
Category |
Date |
Preview |
Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 03-Jul-15 20:46 | | Views : 478 | Let's try this again. I'm still learning to post, so sorry about that guys. I should point out that I purposely kept the upper and lower halves of the cylinders apart as I found out (the hard way, of course) that when slipping down the tightly squeezed rings, I kept breaking them apart. So each half had its respective sized rings slipped on. To make the "V: portion, I simply squeezed the rings to form an elongated "O" to suit the size of the two balsa strips used as formers. Again, a bit of fussing around, but still better than the alternate methods. |
Skyediamonds1985 | Guillows Series 800 - Stearman PT-17 | Build | 03-Jul-15 20:41 | | Views : 489 | urse) that when slipping those tightly squeezed rings, I kept breaking them apart. |
|