| Hangar |
Aircraft |
Category |
Date |
Preview |
| Creosotewind | ACE M-4 Sherman Tank | Parked | 15-Nov-10 14:03 |  | | Views : 655 | | The turret hatch could rotate on a ball bearing race. The race could let in water so the turret had a raised lip around the hatch. I used solder to make the ring and then feathered the edge with balsa filler. There should only be one ring at the top of the turret. Let that be a lesson, screwdrivers and sharp objects don't always mix. |
| Creosotewind | ACE M-4 Sherman Tank | Parked | 15-Nov-10 13:59 |  | | Views : 610 | | A bit more detail of the 75mm. I need to drill out the barrel. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| Creosotewind | ACE M-4 Sherman Tank | Parked | 13-Nov-10 09:15 |  | | Views : 640 | | I wasn't looking forward to cutting out the suspension system by hand. I mentioned to my brother that I was looking for either a bandsaw or scroll saw. A couple days later I found this on my porch with a note from him saying he wasn't using this one and hopefully I could put it to good use. What a brother. |
| Creosotewind | ACE M-4 Sherman Tank | Parked | 13-Nov-10 09:14 |  | | Views : 558 | | The 75mm barrel. The paper will be glued to the back of the barrel housing. I need to add screw details yet. |
|
