| Hangar |
Aircraft |
Category |
Date |
Preview |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 20-Sep-17 08:58 |  | | Views : 307 | | BUILDING THE FLOATS - It was difficult cutting and getting the printwood parts right. All of the float formers sat crooked when standing on the float keels, because I cut them out crooked with the exacto knife - I had to sand them all to a right angle perpendicular edge mating surface. And all of my 10 second Cyano Acrylate "CA" glue bottles were either rock hard in the bottle, or had lost all of their potency. Luckily, I had one bottle of CA super glue from Dolarama - but it was 30 second glue, not 10 second glue - I found out the hard way ... |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 19-Sep-17 07:15 |  | | Views : 319 | | On Saturday October 14, there will be a "MODEL SHOW", open to everyone, inside the Historic Hangar at Windsor Airport, from 10 am to 3pm, open to all categories of models - airplanes, ships, cars, anything. It's your chance to see some great models, or show off your favorite models, and, if you want, enter your best models into the different categories, each with a prize. Inside the Historic Hangar you can talk to the volunteers who are tirelessly working to restore the Lancaster and Mosquito bombers. There is also a big BBQ with hotdogs and hamburgs for lunch. So bring the kids and have some fun at the Canadian Historical Aircraft Association’s third annual "MODEL SHOW" at the Historic Hangar at Windsor Airport on Saturday October 14, from 10 am to 3 pm, open to all models, and open to everyone. Visit CH2a.ca for details. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 15-Sep-17 21:37 |  | | Views : 311 | | PARTS CUT OUT - I put in a new #11 Exacto blade knife and cut out all of the parts from the "Printwood" balsa sheets (first time). I find that you can even cut against the grain with a sharp blade, a steel ruler, and a "cutting mat". I am still working on the sizing up of all of the notches, and test fitting with a small piece of 1/16" square balsa stringer, to snugly accept the 1/16" square balsa stringers, as close as I can. |
| LASTWOODSMAN | Easy Built FF-62 Fleet Canuck | Parked | 15-Sep-17 21:33 |  | | Views : 446 | | FLEET CANUCK PLAN - here is a pic of the plan - it has FLOATS. The plan actually looks very good - downthrust for the noseblock, positive incidence on the wing, slight negative incidence on the stab, but no incidence on the floats as compared to the fuse datum. I have to make a removable nose block as per the supplied extra sheet of instructions, that came with the kit. There is no removable nose block on the original plan. |
|
