| Build Thread, Page :
<< 4 5 6 7 8 [ 9 ] 10 11 (204 posts, 20 posts per page, 11 pages in total)
|
[ < Prev ] [ Next > ] |
| BillParker, Comment for image # 40778 | 26 Dec 18 14:13 |
| Bri! Way to go! The Gear! You da man! |
| BriandKilby, Comment for image # 40778 | 25 Dec 18 09:45 |
| merry Christmas, and plenty of models for presents! |
| BriandKilby, Comment for image # 40778 | 23 Dec 18 10:50 |
| thanks don. |
| Don C, Comment for image # 40778 | 23 Dec 18 10:41 |
| Nice! I wish I would have seen this before my P-40. So nice.
|
| BriandKilby, Image # 40778 | 23 Dec 18 09:58 |
retracts down. |
| BriandKilby, Image # 40777 | 23 Dec 18 09:57 |
retracts up. |
| BriandKilby, Comment for image # 40772 | 18 Dec 18 12:15 |
| yes, if I do them right. lol. |
| Don C, Comment for image # 40772 | 18 Dec 18 10:57 |
| Control surfaces going to be moveable? |
| BriandKilby, Image # 40772 | 17 Dec 18 17:56 |
left and center wings. |
| BriandKilby, Image # 40771 | 17 Dec 18 17:55 |
working on the flaps and ailerons. |
| BriandKilby, Image # 40751 | 11 Dec 18 13:49 |
building wing center section. |
| BriandKilby, Comment for image # 40706 | 20 Nov 18 13:11 |
| thanks biplane. |
| biplane guy, Comment for image # 40706 | 20 Nov 18 08:01 |
| Nice work Brian, and it works! |
| Don C, Comment for image # 40706 | 16 Nov 18 10:07 |
| Nice! It looks a whole lot cleaner than mine. |
| BriandKilby, Comment for image # 40706 | 15 Nov 18 14:55 |
| I got it to work don! thanks.
|
| BriandKilby, Image # 40707 | 15 Nov 18 13:10 |
tailwheel down. |
| BriandKilby, Image # 40706 | 15 Nov 18 13:09 |
tailwheel rectracted. |
| BriandKilby, Comment for image # 40623 | 07 Nov 18 15:15 |
| thanks don. |
| Don C, Comment for image # 40623 | 07 Nov 18 14:28 |
| To make a retract instead of gluing the gear to the frame, put a small block at the top of the gear/strut and run a pin through it like you would for the rear peg to hold the rubber. I only did it once. Look at my P-40. I'm sure there are easier ways. Good luck. It's a pain. |
| BriandKilby, Comment for image # 40623 | 07 Nov 18 07:50 |
| thanks dd. |
| Build Thread, Page :
<< 4 5 6 7 8 [ 9 ] 10 11 (204 posts, 20 posts per page, 11 pages in total)
|
[ < Prev ] [ Next > ] |
