I think all is working again now. Please leave a comment on a photo somewhere if something you need is not working still.

Main Menu Home About Browse images Signup Lost password? News Links Help User Login User Name Password View By Hangar View By Aircraft Top Ten Aircraft : (numbers in brackets represent number of images online) Guillows Series 400 - P-51 Mustang (953) Guillows Series 200 - SE5a (941) Guillows Series 800 - Stearman PT-17 (697) Guillows Series 2000 - B-29 Super Fortress (679) Guillows Series 800 - Sopwith Camel (661) Guillows Series 500 - P-40 Warhawk (612) Molt Models Tyro (601) Guillows Series 400 - P-40 Warhawk (553) Guillows Series 1000 - F4U Corsair (520) Guillows Series 2000 - B17 Flying Fortress (504) ... View All Aircraft Top Six Manufacturers : Guillows Scratch Built Dumas Dave Diels Engineering, Inc Comet ManzanoLaser ... View All Manufacturers

Browse Images Virtual Aerodrome Image Browser ( Small / Large ) Show : All | Parked | Flying | Build | Aerial | Reference Page (168 in total) :  <<   2   3   4   5   6  [ 7 ]  8   9   10   11   12   >>  [ < Prev ] [ Next > ] Hangar Aircraft Category Date Preview Skyediamonds1985 Guillows Series 900 - P-51 Mustang Reference 08-Jun-18 08:25 Views : 464 Delving a bit deeper revealed just s slight difference. As will be seen on the next post. Skyediamonds1985 Guillows Series 900 - P-51 Mustang Reference 08-Jun-18 08:24 Views : 446 I enlarged a set of 3-views to scale and was surprised to find that Guillow's fuselage matches the 3-views fairly close Hangar Aircraft Category Date Preview Skyediamonds1985 Guillows Series 400 - P-51 Mustang Build 07-Jun-18 01:05 Views : 930 Hey, not too bad, eh? I tried a combination of small panels, butt panels, overlapping panels, single and double rivet patterns. All came out really nice. Total application time for all of the small section panels and rivets, about 15 minutes. Skyediamonds1985 Guillows Series 400 - P-51 Mustang Build 07-Jun-18 01:03 Views : 904 This time I purchased a set of "pounce wheels" from MicroMark to be used to reproduce rivets on the backside for the rivet patterns to be seen on the front side. I only needed to run down the pounce wheel along a straight edge. No mind-numbing tapping of the hammer over tens of thousands of faux rivets. Page (168 in total) :  <<   2   3   4   5   6  [ 7 ]  8   9   10   11   12   >>  [ < Prev ] [ Next > ]