Build Thread, Page :
1 2 [ 3 ] 4 5 6 7 8 (149 posts, 20 posts per page, 8 pages in total)
|
[ < Prev ] [ Next > ] |
Steve_in_NH, Image # 27970 | 20 Nov 12 18:41 |
|
Steve_in_NH, Image # 27969 | 20 Nov 12 18:39 |
Bottom view. |
Steve_in_NH, Image # 27968 | 20 Nov 12 18:38 |
Masking in place for painting. Silver base with red tail and blue nose. |
Steve_in_NH, Image # 27967 | 20 Nov 12 18:37 |
|
Steve_in_NH, Image # 27966 | 20 Nov 12 18:34 |
|
Steve_in_NH, Image # 27965 | 20 Nov 12 18:34 |
|
Steve_in_NH, Image # 27964 | 20 Nov 12 18:34 |
All glued together and ready for final sanding and then paint. |
Steve_in_NH, Image # 27943 | 18 Nov 12 15:17 |
|
Steve_in_NH, Image # 27942 | 18 Nov 12 15:16 |
|
Steve_in_NH, Image # 27941 | 18 Nov 12 15:16 |
|
Steve_in_NH, Image # 27940 | 18 Nov 12 15:14 |
|
Steve_in_NH, Image # 27939 | 18 Nov 12 15:14 |
First coat of primer. Needs just a little clean up around the edges but all in all primer coat is ok. |
Steve_in_NH, Image # 27938 | 18 Nov 12 15:12 |
Top view. |
Steve_in_NH, Image # 27937 | 18 Nov 12 15:11 |
Covering came out well. I'm happy with the result. |
Steve_in_NH, Image # 27936 | 18 Nov 12 15:10 |
Bottom viw. ready for primer. |
Steve_in_NH, Image # 27935 | 18 Nov 12 15:09 |
|
Steve_in_NH, Image # 27934 | 18 Nov 12 15:08 |
Wig finally covered. Still just temp pinned. |
Steve_in_NH, Comment for image # 27932 | 18 Nov 12 10:56 |
Thanks for the tips guys. I'll try them both. |
frwyflyer, Comment for image # 27930 | 18 Nov 12 06:52 |
Did you use enamel pint on the canopy? If you did you can clean it off with paint thinner and start over. Paint thinner will not harm the plastic |
Dale1416, Comment for image # 27930 | 17 Nov 12 21:55 |
I usually apply 3 coats of Liquid Masking Film allowing each coat to dry. Scoring with a sharp X-acto knife should give you crisp edges. |
Build Thread, Page :
1 2 [ 3 ] 4 5 6 7 8 (149 posts, 20 posts per page, 8 pages in total)
|
[ < Prev ] [ Next > ] |