Build Thread, Page :
1 2 3 4 [ 5 ] 6 7 8 (149 posts, 20 posts per page, 8 pages in total)
|
[ < Prev ] [ Next > ] |
Steve_in_NH, Image # 27875 | 11 Nov 12 20:18 |
|
Steve_in_NH, Image # 27874 | 11 Nov 12 20:18 |
Bottom stringers doubled. |
Steve_in_NH, Image # 27873 | 11 Nov 12 20:17 |
3/32 stringer installed on trailing edge to facilitate covering. It gives you more to adhere the silkspan to on the very edge. |
Steve_in_NH, Image # 27872 | 11 Nov 12 20:16 |
|
Steve_in_NH, Image # 27871 | 11 Nov 12 20:15 |
Second coat of primer on fuselage and all wing stringers doubled. Landing gear also fabricated. |
Steve_in_NH, Image # 27854 | 09 Nov 12 20:29 |
|
Steve_in_NH, Image # 27853 | 09 Nov 12 20:28 |
|
Steve_in_NH, Image # 27852 | 09 Nov 12 20:27 |
Under side of wing. Stringers to be doubled here as well. |
Steve_in_NH, Image # 27851 | 09 Nov 12 20:26 |
|
Steve_in_NH, Image # 27850 | 09 Nov 12 20:24 |
small wooden pegs in exhaust ports to preserve black paint inside the drilled out exaust |
Steve_in_NH, Image # 27849 | 09 Nov 12 20:23 |
First coat of primer on fuselage and wing with standard stringers (3/32) installed. Will double up stringers next. |
Steve_in_NH, Image # 27829 | 07 Nov 12 17:00 |
Canopy trimmed and fitted. |
Steve_in_NH, Image # 27828 | 07 Nov 12 16:59 |
|
Steve_in_NH, Image # 27827 | 07 Nov 12 16:59 |
Inside of door pieces. |
Steve_in_NH, Image # 27826 | 07 Nov 12 16:59 |
Tail wheel doors. Carved the cover of the opening as one piece and then cut the door piece free and then split it down the middle for later installation when ready for paint. |
Steve_in_NH, Image # 27825 | 07 Nov 12 16:57 |
|
Steve_in_NH, Image # 27824 | 07 Nov 12 16:56 |
Tried to follow Dave Duckett's instructions on preparing the propeller assembly. Took me about 2 hours to get this right. Post will still need to be trimmed to correct leng |
Steve_in_NH, Image # 27823 | 07 Nov 12 16:54 |
|
Steve_in_NH, Image # 27822 | 07 Nov 12 16:54 |
You can see what I mean by sanding the contour. Was difficult to plank. Hope filler will cover up my poor planking |
Steve_in_NH, Image # 27821 | 07 Nov 12 16:52 |
Waiting for filler to dry so I can sand this tricky contour. |
Build Thread, Page :
1 2 3 4 [ 5 ] 6 7 8 (149 posts, 20 posts per page, 8 pages in total)
|
[ < Prev ] [ Next > ] |